One of the challenges is how to mount it due to the rear track for the rack and pinion fence. I took inspiration from a few others that I came across on the internet and built mine to store in a small space and simply lift on and off the saw. Quote from: Dick Mahany on July 26, 2018, 06:20 PM Here is a quick assembly, compact outfeed table for a DeWalt jobsite saw. I think between the improvements I made to the fence and this mobile outfeed I'm after I'll have one slick setup that can go outside with an MFT/3 if I want it to. I'm after a mobile setup that I can get going fast and put away just as quickly. I was keeping my saw on a shelf before and I don't have to tell you how inconvenient it was. Yes the stand I purchased is incredibly stable. It's on wheels and I could see moving it up to the saw when I need it for outfeed. When I built my Vac Sys cart I made the height of it slightly higher than an MFT and it comes in at about 905mm floor to top. If you were to get an MW1000 extension table you could do what I'm attempting without tying up your MFT/3. I know that sounds excessive but I bought them all second hand at about half off. I have two MFT/3's dedicated to working and a third that's a floater for whatever I need that stays folded up. You can grab my email via PM if you're willing to share, or if there's a way to link to it for others as well.

I had to use something Festool for this Mahany That would be great I'd like to see the PDF. This gap has never been a problem in practice.

The rear clearance is just enough to allow the rear fence mount to slide without contacting the outfeed table. I can assemble this more than one way, hence the orientation arrows below haha. Slick surface and easy to maintain.Īnother FOG member asked about it so here it is. I also used a trick I learned from David Stanton's videos and that was to sand the top to 220 grit and then use paste wax and power buff with a ROS and steel wool. The sides are made from 15mm Baltic Birch and the top is made from awful home center nominal 3/4' birch face ply. It is actually quite simple, however since it mounts on and off a welded tube assembly, I built this one in place on the saw as I wanted to assure the extension was parallel to the saw table. Here is a quick assembly, compact outfeed table for a DeWalt jobsite saw.

Dewalt table saw work extension